Shield form factor Every Arduino shield must have the same form-factor as the standard Arduino. Power and ground pins on one eight (previously six) pin header, and analog pins on a six-pin header next ...

We got it running on an Arduino Leonardo the quickest, because it has support for Serial1(). Don’t be discouraged by these glitches in this rev 0 deployment — [Eric] has really made quite a ...

In a previous article, we looked at connecting various kinds of Arduino hardware to your Mac. Here's how to get started programming on them to create your own projects.

The shield is fully configurable with jumpers to connect or disconnect each Raspberry Pi and Arduino pin from the level-shifters to allow for full use of all pins and ports.

Arduino pins, and almost everything else at a standard hobbyist scale, are 0.1" pin spacing - so I just soldered the sense wires to some 0.1" headers I have laying around.

When getting started with Arduino, it is good to have a shield with a lot of integrated components to get used to how to interact with the different sensors and displays. TK shows us how to get ...

You can use these pins with your projects. The Arduino Nixie Tube SHIELD is now available to back via indigo go with pledges starting from $25 and shipping expected to take place during December 2017.

As you can see from that sketch and the circuit diagram, the LED is connected to the digital pin 13 of the Arduino. Once you verify (compile) the sketch and upload it to the Arduino board, you should ...

The laser interface could be a bit more eloquent, and we’re wondering just how much current it is pulling off of the Arduino pins.

How to Light Your Jack-o'-Lantern the Arduino Way Learn about Pulse Width Modulation and give your Jack-O-Lanterns a warm pulsing glow.